Geist Repel ceramic for leather

Description:

Box contents:

• Geist. Repel 50 ml
• Microfiber applicator
• Microfiber cloth

What is it?

A next-generation solvent-free hybrid polymer coating specially formulated for leather, vinyl, and synthetic leather. Its formula repels clothing dyes, dirt, pen marks, and discoloration from child seat rubber, as well as UV cracking and fading.

• Suitable for all types of automotive leather, vinyl, polyurethane, and vegan leather. Test before use on aniline/porous leather.
• Very easy to apply, only requires one coat.
• Repels dirt, prevents discoloration, and protects against friction damage and cracking caused by UV rays.
• Free of ceramic nanoparticles and other nanoparticles.
• Solvent-free.
• No microplastics.
• Easily withstands cleaning with a wet brush.
• It is detergent resistant: it can be cleaned and continues to protect.
• Excellent resistance to dyes even in humid conditions!
• It makes cleaning coated surfaces much easier, even after prolonged use.
• It has no health or hazard warning label.
• Safe for all types of leather and synthetic top-coated surfaces.

Frequently Asked Questions:

Q: How long does it last?
A: Over 12 months / 25,000 km under normal conditions (Outperformed all other ceramic coatings tested in long-term wet and dry testing).

Q: How should I store the product after use? What is its shelf life once opened?
A: Store above 5°C and below 35°C. Frost sensitive.

Q: Can I apply multiple coats?
A: One coat is sufficient. Two or more coats enhance the protective effect.

Q: Can I apply additional sealant/wax on top?
A: Yes, we recommend using Geist Dye & Friction Blocker for maintenance purposes.

Q: How long does it take for the product to dry/cure?
A: Being a water-based product, the vehicle can be used once the coating has dried and the surface is dry to the touch. The coating takes 48 hours to reach full strength.

Q: How do you maintain a vehicle coated with this product?
A: We recommend using Geist Quick Leather Cleaner followed by Geist Dye & Friction Blocker (available together in the Geist 3 Minute Care Kit). For very light cleaning, you can also use Geist Surface & Screen Cleaner.

Q: Can it be removed?
A: Yes, if necessary (for example, if a surface needs to be repaired), clean thoroughly with Geist Quick Cleaner PRO and brush (twice) to remove the coating.

Q: Is it a breathable coating? Why? How?
A: Yes, microscopic images show that even the smallest pores remain open. The flexible micropolymer allows air and moisture to penetrate the surface.

Q: How and where do other products fit in?
A: Most protected automotive leathers require occasional light cleaning for hygiene reasons. Perspiration, contamination, and spills (sugar, grease) can be easily removed with Geist Rapid Cleaner.

Q: What if there are still stains?
A: If stains penetrate, Geist Repel makes them easy to remove. For example, Geist Dye and Ink Remover is a solvent-free product that removes many colored stains without damaging the surface.

Q: Will it yellow white seats?
A: No, Geist. Repel is stable even in intense sunlight, as it contains an effective UV filter.

Instructions:

• Make sure the surface is clean and dry. Test on an inconspicuous area before use.
• Spray a small amount of product onto the included applicator and apply evenly to the surface using circular motions. Make sure to cover the entire seat, especially in high-traffic areas. Let air dry for 15 to 20 minutes. Then, use a microfiber cloth to gently buff until you achieve a smooth, matte finish.
• If necessary, repeat the application to ensure adequate and even coverage. Two thin coats are usually better than one thick one.
• If streaks appear after drying, lightly moisten the applicator with the product again, apply a thin layer to the affected area, and buff immediately.
• Faux leather (e.g., vegan leather): The product may appear uneven at first before drying, but light polishing after drying will smooth it out and make it even.